Treble bleed - .001uf 100V / 225p Serie Orange Drop - 100K Allan Bradley 1/4 Watt Vintage Carbon Resistor - Guitar & Bass.
Premium Components - Cornell Dubilier (CDE) Orange Drop® Capacitors - Allan Bradley vintage resistor.
A 0.001uf capacitor and a 100K or 150KOhm resistor are common values used for Treble Bleed. Prefect for Fender, Gibson and guitar with 'single and Humbucker pickup'.
Personally, I use 100V capacitors for single pickups wiring and 600V capacitors for humbuckers pickups wiring.
Capacitance: .001uF
Maximum Voltage: 100V
Tolerance: ±3% to ±10%
Series: 225P
Material: Polypropylene Film
Width: 0.63" = 5/8" = 16.00mm
Height: 0.27" = 9/32" = 6.85mm
Depth: 0.18" = 3/16" = 4.57mm
Lead Length: 1.95" = 50mm
Lead Spacing: .54" = 13.71mm
Any questions... please feel free to contact us.
Thanks for visiting BadAss Tone
Duncan Mod - Treble Bleed .001uf / 100V - 100K A Bradley Resistor - (Pair)
What is the purpose of a treble Bleed ?
A treble-bleed circuit allows high frequencies to Bleed (or pass) through the volume control, even when the volume is turned down. “It's a common modification people have been doing for a while”.
What is a "Treble Bleed" ?
A treble bleed is a capacitor alone or coupled to a resistor, either in parallel, series, or both (parallel and series are more common on some Fenders).
How to install it ?
It should be soldered to the center and outer lug of the volume pot.
In the early days of Treble Bleed, many people just used a capacitor. What we now call the "Simle Mod", but using only the capacitor, many guitarists and technicians found that when they turned down the volume, they kept the highs but also removed a lot of the bass. By adding a resistor to the condenser, some guitarists and technicians were able to correct this lack of bass while keeping the highs. This is how Fender created the Tone Saver.
4 Popular Treble Bleed Mods: (SIMPLE no resistor) - (DUCAN resistor parallel) - (KINMAN resistor series) (Fender American serie resistor parallel and series) See Diagram.Note: If you are not satisfied with your purchase, you may return it. The return must be done within a maximum of 30 days following the reception of the article. In this case, you will be asked for the order number and the item to return.
In order for us to accept a returned item, it MUST be unused and in the same condition as it was shipped (this means that you have not been welded or cut, etc.).